E N G L I S H
Keep children and animals at
x
a safe distance when using
this appliance.
Never pull the power lead to
x
disconnect the plug from the
cigarette lighter socket.
Keep the lead away from
heat, oil and sharp edges.
Be careful not to pinch the
x
lead in the vehicle's doors,
windows or levers.
After use
When not in use, the appliance
x
should be stored in a dry place.
Children should not have
access to stored appliances.
Inspection and repairs
Before use, check the appliance
x
for damaged or defective
parts. Check for breakage of
parts, damage to switches
and any other conditions that
may affect its operation.
Do not use the appliance if any
x
part is damaged or defective.
Have any damaged or
x
defective parts repaired or
replaced by an authorised
repair agent.
Regularly check the power lead
x
for damage. Replace the lead
if it is damaged or defective.
Never attempt to remove or
x
replace any parts other than
those specified in this manual.
ELECTRICAL SAFETY
The appliance is designed for use
with 12 V negative ground
vehicle battery systems.
Do not operate the
appliance with systems
which have positive ground
or a different voltage.
The cigarette lighter socket may
not be live when the ignition is
off and/or the key is removed.
6
If in doubt, consult your vehicle's
owner's manual for information
regarding the above.
USE
Connecting to the vehicle's
power supply (fig. B)
Make sure that the appliance
x
is switched off.
Remove the cigarette lighter
x
from the socket.
Plug the connector (4) into
x
the cigarette lighter socket.
Operating the appliance (fig. C)
To switch on, slide the on/off
x
switch (1) forward.
To switch off, slide the on/off
x
switch back.
The appliance can be used for
x
periods of up to 30 minutes
without noticeably affecting
the power of a normally
charged car battery in good
condition.
Extended use will drain the
battery power.
Do not run the vehicle's engine
x
while cleaning. This can shorten
the life of the appliance.
Accessories (fig. D & E)
The appliance is supplied with
the following accessories:
- a hard brush (5) for upholstery
- a crevice tool (6) for confined
spaces
The accessories are stored
beneath the rear of the
appliance.
To fit an accessory, proceed as
follows:
Take the accessories from the
x
appliance.
Insert the appropriate
x
accessory into the front of the
appliance.