Settings For Each Type Of Battery; Settings - Cristec CPS2 Bedienungsanleitung

3.2.3 Settings for each type of battery

Type of
battery
SW5
TYPE-1 BAT.
Calcium Lead
OFF
Tin (e.g.:
Delphi/Delco
Freedom)
TYPE-2 BAT.
OFF
Lead Sealed
TYPE-3 BAT.
OFF
Gelled Lead or
Calcium Lead
TYPE-4 BAT.
Open Lead
with
ON
maintenance
(free
electrolyte)
WINTERING
for TYPE-1
OFF
BAT.
TYPE-2 BAT.
TYPE-3 BAT.
WINTERING
ON
For TYPE-4
BAT.
(*)Voltage on BAT 1/BAT 2 with 10% of rated current and a tolerance of +/- 1%
Voltage on BAT D = BAT 1 or BAT 2 – approx. 0.4V

3.2.4 Settings

The charger's factory settings are:
TYPE-2 BAT. Sealed Lead (see table above)
BOOST in ON position
The installer should set the switches (excluding input and off-load output voltage) and possibly adjust the
output voltage using potentiometer RV1 (use the appropriate tool to turn the screw of the potentiometer),
depending on:
- the type of battery (contact the battery manufacturer if necessary)
- intended usage
Switch positions
SW4 SW3 SW2
OFF OFF ON
OFF OFF
ON
ON OFF OFF
OFF OFF OFF
ON OFF OFF
OFF OFF OFF
CPS2DEA.DOC
CPS2 12V
Voltage Voltage
Phase Phase
SW1
*
Boost Floating
Boost
ON 15.1V 14.4V
14.3V 13.6V
ON
ON 14.1V 13.4V
ON 13.7V 13V
ON 14.1V 13.4V
ON 13.7V 13V
CPS2 24V
Voltage Voltage
Phase Phase
* * *
Boost Floating
30.2V 28.8V
28.6V 27.2V
28.1V 26.8V
27.3V 26V
28.1V 26.8V
27.3V 26V
CPS2 48V
Voltage Voltage
Phase Phase
* *
Boost Floating
60.5V 57.6V
57.1V 54.4V
56.3V 53.6V
54.6V 52V
56.3V 53.6V
54.6V 52V
28