Herunterladen Inhalt Inhalt Diese Seite drucken

Led Indication - Hitachi YUTAKI M-Serie Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für YUTAKI M-Serie:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 71
ELECTRICAL AND CONTROL SETTINGS
Unit and installation pipes antifreeze
protection
Standard / ECO water pump operation
Electric heater or boiler emergency mode
DHW tank's heater operation
DHW 3-way valve forced ON
!
C A U T I O N
Never turn all DSW4 dip switch pins ON. If this happens, the software
of the unit will be removed.
Never activate "Heater Forced OFF" and "Electric heater or boiler
emergency mode" at the same time.

DSW5: Additional setting 3
In the cases where the outdoor unit is installed into a location
where its own outdoor ambient temperature sensor can not
give a suitable temperature measurement to the system, it
is available the 2nd outdoor ambient temperature sensor as
accessory. By means of DSW1&2 setting, the preferable sensor
for each circuit can be selected.
Factory setting
Outdoor unit sensor for circuits 1 and 2.
Outdoor unit sensor for circuit 1; Auxiliary
sensor for circuit 2.
Auxiliary sensor for circuit 1; Outdoor unit
sensor for circuit 2.
Auxiliary sensor instead of outdoor unit
sensor for both circuits.
4-20 mA setting temperature
(Only manual operation)
Use the maximum temperature value
between Two3 (boiler / heater thermistor) and
Two (water outlet thermistor) for water control
23
PMML0342B rev.1 - 03/2016
All manuals and user guides at all-guides.com

Factory setting
7
8
(Do not change)

7
8
Factory setting
7
8
Defrost for the water electric heater
7
8

7
8
Factory setting
(Do not change)

Factory setting
(Do not change)

Factory setting
(Remote operation)
Local operation

Factory setting
(Heat operation)
Cool and Heat operation in case of Local

9.5.4 LED indication

Name
LED1
LED2
LED3
LED4
LED5
LED6
LED7
DSW6: Not used
DSW7: Additional setting 4
DSW8/DSW18: Not used
DSW15 & RSW2/ DSW16 & RSW1: Not used
SSW1: Remote/Local
SSW2: Heat/Cool
Colour
Green
Power indication
Red
Power indication
Red
Heat pump operation (thermo ON/OFF)
Yellow
Alarm (flickering with 1 sec interval)
Green
Not used
Yellow
H-Link transmission
Yellow
H-Link transmission for unit controller
Remote
Local
Remote
Local
Heat
Cool
Heat
Cool
Indication

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis