Foreseeable Misuse; Modifications To The Product; Warnings; Safety Notes - oventrop Multidis SFQ Betriebsanleitung

Safety-related information
damage caused by incorrect use will not be
accepted.
Observance of the operating instructions is part
of compliance with correct use.

2.3 Foreseeable misuse

Constructive measures are not sufficient to
exclude misuse.
The following must therefore be avoided:
• Mixing up of supply and return.
• Operation with aggressive fluids (e.g.
steam or oil).

2.4 Modifications to the product

Modifications to the product are not permitted.
In case of modifications to the product, the
warranty will become void. The manufacturer
will not accept liability for damage and break-
downs caused by modifications to the product.

2.5 Warnings

Each warning contains the following elements:
Warning symbol
SIGNAL WORD
Type and source of danger
Possible consequences if the danger
occurs or the warning is ignored.
f Ways to avoid the danger.
The signal words identify the severity of the
danger arising from a situation.
NOTICE
Indicates a situation that may lead to
damage to property if not avoided.

2.6 Safety notes

We have developed this product in accordance
with current safety requirements.
Please observe the following notes concerning
safe use.
18
2.6.1 Danger caused by inadequately
qualified personnel
Any work on this product must only be carried
out by qualified tradespeople.
Qualified tradespeople
As a result of their professional training and
experience as well as their knowledge of the
relevant legal regulations, qualified trades-
people are able to carry out any work on the
described product professionally.
2.6.2 Risk of injury from pressurised
components
f Only carry out work when the system is
depressurised.
f Observe the permissible operating pres-
sures during operation.
2.6.3 Risk of burns due to an
uncontrolled discharge of hot
fluids
f Only carry out work on the heating/cooling
circuit when the system is depressurised.
f Check that the product is not leaking after
work is complete.
f Wear safety goggles.
2.6.4 Risk of burns due to hot
components and surfaces
f Allow the product to cool down before
working on it.
f Wear suitable protective clothing to avoid
unprotected contact with hot system com-
ponents and fittings.
2.6.5 Risk of injury in case of improper
work
Stored residual energies, angular components
points and edges at the outside and inside of
the product may cause injuries.
f Before starting work, make sure that there
is enough space.
f Handle open and hard-edged components
with care.
f Make sure that the work place is tidy and
clean to avoid accidents.
Multidis SFQ
140495281-V01.12.2020