Instructions For Use - Proscenic M8 PRO Bedienungsanleitung

Instructions for use

Instructions for robot
Power on / off
Press and hold the " " button to power on, and the host enters the standby
state. After booting, press and hold the "
Note: When the host is charging on the dust collector, it will automatically turn
on, and it cannot be turned off during charging.
Start / pause
Under the power on state, short press the "
cleaning.
Press any key to pause while cleaning.
Note: It is recommended that the sweeping robot start cleaning from the dust
collector;
When the battery is too low, the cleaning will not start.
Please charge and then start cleaning.
When the power is insufficient during the cleaning process, the host will
automatically return to the dust collector unit for charging.
After the battery is fully charged, it will automatically return to the interruption to
continue cleaning.
Instructions for dust collector
Start/Stop Button
Short press: Start auto cleaning / pause cleaning
Press and hold for 3s: Start spot cleaning
Pairing of dust collector and robot (Factory paired in default)
1. Press and hold the both buttons
the dust collector flash green;
2. Press and hold the button for 5 seconds on the robot: The robot goes into pairing mode, the indicators of the robot flash green;
3. Place the robot at the dust collector to charge, and the voice prompts that the pairing is successful.
" button to shut down.
" button to start the whole house
and on the dust collector for 5 seconds simultaneously: The dust collector goes into pairing mode, the three indicators of
Charging
Automatic recharge: The host will automatically return to the dust collector unit
to charge after the cleaning is completed or when the battery is insufficient.
Manual charging: Press the "
powered off, you can manually put the host back into the dust collector unit to
charge.
Note: Please make sure the charging pole piece is in good contact.
Sleep
If there is no operation for more than 20 minutes, the host will automatically
enter into sleep state.
Note: The host will not enter the sleep state when charging;
Automatically shuts down after sleeping to no power.
Home button
Short press: Return to collect dust and charge
Press and hold for 3 seconds: Return to collect dust and then continue to clean
from the place where it left off last time
8
" button to start recharging; after the host is