Technical Data - Grillo CL 700 Handbuch

Before leaving the drive-seat:
a) disconnect the blade;
b) switch off the engine.
Do not travel along gravely ground, or in places covered with burnt ground and always avoid the machine transport
from a place to another, if you have not disconnected the blade.
Avoid the cutting:
a) near residential areas;
b) near passages;
c) near rest areas.
Do not let use the grass-cutter lawn mower by anyone who has not read the manual.
Pay attention not to slip on the slopes, above all when the grass is wet.
Do not prune, pulling the machine against you.
For the transport with vehicles different from your machine
IDENTIFICATION AND TECHNICAL ASSISTANCE
S.p.A.
C E S E N A - I TA LY
tipo CLIMBER 700
serie 000000
massa c.a. kg. 120
anno
TECHNICAL ASSISTANCE
This manual provides instructions for use and basic maintenance of the mower by the user.
For operations that are not described in this manual, contact your Area Dealer.
SPARE PARTS
Only use original spare parts. These are the only parts that ensure safety and interchangeability.
Always quote the machine's serial number and the code number of the part to be replaced when ordering spare
parts.
For engine parts, follow the indications given in the specific manual.
GUARANTEE
The guarantee is provided according to the terms indicated on the guarantee card.
For the engine and the battery, the provisions of the relative manufacturers apply.
RECOMMENDED LIST OF SPARE PARTS TO BE KEPT IN STORE
2 x mowing blades
2 x blade screws
2 x blade screw nuts
1 x set of belts
1 x air filter for engine
1 x accelerator wire

TECHNICAL DATA

ENGINE: HONDA GXV 340 – OHV petrol engine, 4-stroke, 8 kW (11 hp).
A : BRIGGS & STRATTON INTEK 344 - OHV single cylinder petrol engine, 4-stroke, 7,7 kW
LTERNATIVELY
(10,5 hp), fitting cast iron cylinder and provided with oil pump, oil filter.
STARTING SYSTEM: pull starter with automatic rewind.
GEAR SYSTEM: hydrostatic transmission.
SPEED: with continuous variation, forward max. 6 km/h, reverse max. 3,5 km/h.
HOURLY CUTTING CAPACITY: 2500 m
CUTTING HEIGHT: 35-65-95-125 with easy adjustment from the handlebar.
CUTTING WIDTH: 700 mm.
IDENTIFICATION
The Grillo CL 700 has a label, indicating the machine's serial
number.
KW/giri minuto
2
/h.
10