Rear Panel; Sockets Panel; Accessories; General - voestalpine Bohler Welding TERRA 500 RC Bedienungsanleitung

3.5 Rear panel

1 Power supply cable
Connects the system to the mains.
2 Off/On switch
Turns on the electric power to the welder.
It has two positions, "O" off, and "I" on.
3 Power cable input (WF)
4 Signal cable input (WF)
5 Remote control

3.6 Sockets panel

1 Earth socket
Earth wire connector.
2 Positive power socket
For connection of electrode torch in MMA.

4 ACCESSORIES

4.1 General

Operation of the remote control is activated when connected
to the power sources. This connection can be made also with
the system power on.
With the RC control connected, the power source control panel
stays enabled to perform any modification. The modifications
on the power source control panel are also shown on the RC
control and vice versa.

4.2 RC 100 remote control

The RC 100 is a remote control unit designed to manage the
display and the adjustment of the welding current and voltage.
"Consult the instruction manual".

4.3 RC 180 remote control

This remote control unit makes it possible to change the output
current without interrupting the welding process.
"Consult the instruction manual".

4.4 RC 190 remote control

1
Allows continuous adjustment of the wire feed speed.
Allows the regulation of the welding current.
Allows the thickness of the part being welded to be set.
Allows the setting of the system via the regulation of the
part being welded.
25