What You Should Pay Attention To; Igniting And Adjusting - Atag HG75..B Bedienungsanleitung Und Installationsanweisung

safety

what you should pay attention to

general
Before installing the appliance, check that the type of gas and
the gas pressure are in accordance with the appliance's
specifications.
When using a metal connecting pipe, make sure that it
cannot get damaged or pinched.
The use of gas cooking appliances releases heat and
moisture into the room in which the appliance is fitted. Take
care that the room is sufficiently ventilated; keep natural
ventilation openings open or install a mechanical ventilator
(extractor hood).
If the hob is in use for a long time, extra ventilation may be
necessary – for example, an open window, or a higher setting
for the ventilator (extractor hood).
during use
This cooking appliance has been designed for domestic use.
Only use it for preparing foods.
Do not use the appliance to heat the kitchen. This will cause
the atmosphere to become damp.
Flambéing under an extractor hood is not permitted. The high
flames can cause a fire, even when the extractor hood is
switched off.
The appliance is hot during and after use. Bear this in mind if
young children come anywhere near the appliance. Do not
leave young children alone near a hot cooking appliance.
flame protection
(HG75..B) (not available in every country)
This appliance is fitted with a thermocouple. This is a
thermoelectric protection system. It ensures that the gas tap
is closed if the flame goes out.
It is important that you check regularly whether or not this
protection system is working properly.
GB 4
testing
1. Blow out the flame and wait for one minute. The gas tap now
closes, and no more gas should come out of the burner.
2. Hold a lighted match next to the burner. The burner should
not ignite now. If it does, you should contact the service
department immediately.
attention!
The distance from a knob or a non heat resistant wall is always
greater than 2 cm. If the pan is nearer, the knobs or the wall
may become discoloured or deformed.
Pans with a diameter greater than 24 cm should preferably be
put on the rear burner.
igniting
0-setting
high setting
low setting
burner indication
1. Turn the control knob to the position required, between the
high and low settings.
2. Press the control knob (and keep it pressed for about
5 seconds / HG75..B).
The burner ignites.
If the burner does not ignite, check whether:
– the cap is on the burner properly;
– the burner is clean and dry;
– the control knob has been pressed long enough (only
HG75..B).
adjusting
The burner is continuously adjustable between the high and low
settings.
controls

igniting and adjusting

GB 5