Installation; Connection Cable; Before The Installation; Built-In Hobs - AEG HC452401EB Benutzerinformation

16 www.aeg.com
Problem
comes on.
comes on.
comes on.
7.2 If you cannot find a
solution...
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre. Give the
data from the rating plate. Give also
three digit letter code for the glass
ceramic (it is in the corner of the glass

8. INSTALLATION

WARNING!
Refer to Safety chapters.

8.1 Before the installation

Before you install the hob, write down
the information bellow from the rating
plate. The rating plate is on the bottom
of the hob.
Serial number ...........................

8.2 Built-in hobs

Only use the built-in hobs after you
assemble the hob into correct built-in
Possible cause
The electrical connection is
incorrect. The supply voltage
is out of range.
There is an error in the hob
because a cookware boiled
dry. Automatic Switch Off
and the overheating protec-
tion for the zones operate.
The cooling fan is blocked.
surface) and an error message that
comes on. Make sure, you operated the
hob correctly. If not the servicing by a
service technician or dealer will not be
free of charge, also during the warranty
period. The instructions about the
Service Centre and conditions of
guarantee are in the guarantee booklet.
units and work surfaces that align to the
standards.

8.3 Connection cable

• The hob is supplied with a connection
cable.
• To replace the damaged mains cable
use the following (or higher) mains
cable type: H05V2V2-F T min 90°C.
Speak to your local Service Centre.
8.4 Attaching the seal
1. Clean the worktop around the cut
out area.
Remedy
Speak to a qualified electri-
cian to check the installation.
Deactivate the hob. Remove
the hot cookware. After ap-
proximately 30 seconds, acti-
vate the zone again. If the
cookware was the problem,
the error message goes out.
Residual heat indicator can
stay on. Let the cookware
become sufficiently cool.
Check if your cookware is
compatible with the hob.
Refer to "Hints and tips"
chapter.
Check if objects block the
cooling fan. If comes on
again, speak to an Author-
ised Service Centre.