Fronius MAGIC WAVE 2000 FUZZY Bedienungsanleitung & Ersatzteilliste Seite 29

SAFETY PRECAUTIONS AT THE INSTALLATION
LOCATION
- The welding machine must be placed on an even, firm floor in such a way
that it stands firmly. A welding machine that topples over can easily kill
someone!
- Special regulations apply to rooms at risk from fire and/or explosion.
Observe all relevant national and international regulations.
- By means of internal instructions and checks, ensure that the workplace
and the area around it are always kept clean and tidy.
SAFETY PRECAUTIONS IN NORMAL OPERATION
- Only operate the welding machine if all its protective features are fully
functional.
- Before switching on the welding machine, ensures that nobody can be
endangered by your turning on the machine.
- At least once a week, check the machine for any damage that may be
visible from the outside, and check that the safety features all function
correctly.
SAFETY INSPECTION
The owner/operator is obliged to have the machine checked for proper
condition by a trained electrician after any alterations, installations of additional
components, modifications, repairs, care and maintenance, and in any case
at least every twelve months.
In the course of such inspection, the following regulations must be observed
(as a minimum):
- IEC (EN) 60 974-1 - Arc welding equipment - Part 1: Welding power
sources
- VBG 4, §5 - Electrical plant and apparatus
- VBG 15, §33 / §49 - Welding, cutting and allied processes
- VDE 0701-1 - Repair, modification and inspection of electrical appliances;
general requirements
- VDE 0702-1 - Repeat tests on electrical appliances
Further information on corrective maintenance, modification and inspection of
welding machines is available from your regional or national Fronius service
centre,who will be pleased to provide you with a copy of the Work Instruction
"Safety Inspection of Welding Machinery" (AA-PMÜ-01) upon request.
ALTERATIONS TO THE WELDING MACHINE
- Do not make any alterations, installations or modifications to the welding
machine without getting permission from the manufacturer first.
- Replace immediately any components that are not in perfect condition.
SPARES AND WEARING PARTS
- Use only original spares and wearing parts. With parts sourced from other
suppliers, there is no certainty that these parts will have been designed
and manufactured to cope with the stressing and safety requirements that
will be made of them.
- When ordering spare parts, please state the exact designation and the
relevant part number, as given in the spare parts list. Please also quote
the serial number of your machine.
CALIBRATION OF WELDING MACHINES
In view of international standards, regular calibration of welding machinery
is advisable. Fronius recommends a 12-month calibration interval. For more
information, please contact your Fronius partner!
CE-MARKING
The welding machine fulfils the fundamental requirements of the Low-Voltage
and Electromagnetic Compatibility Directive and is thus CE-marked.
COPYRIGHT
Copyright to this instruction manual remains the property of Fronius Sch-
weissmaschinen Vertrieb GmbH & CoKG.
Text and illustrations are all technically correct at the time of going to print. Right
to effect modifications is reserved. The contents of the instruction manual shall
not provide the basis for any claims whatever on the part of the purchaser.
If you have any suggestions for improvement, or can point out to us any
mistakes which you may have found in the manual, we should be most
grateful.
5
ud_fr_st_sv_00146 012000