Safety Device; Cleaning & Maintenance - EUROM PD2100 XXL Gebrauchsanweisung

* is earthed;
* gives out the correct voltage (220/240V~50Hz);
* has at least a 16 A fuse;
* is secured with a 30 mA earth switch;
* is located in a safe, dry place.
When everything is as it should be, you can place the plug in the socket and then
press one or both switches, whereupon the terrace radiator will begin to work.
Switch I pressed = 900 Watts
Switch II pressed = 1200 Watts
Switch I + II pressed = 2100 Watts
During the first couple of minutes after connection, two dark dots will be visible on
the surface of the heating elements. This is perfectly normal and does not affect its
operation. When you use the device for the first time (or for the first time in a long
while), you will have to closely observe the device for the first 10 to 15 minutes to
be certain that it is working without any problems.
If you want to adjust the height or power or to turn off the terrace radiator, you
should press the switches again until the power status is switched to off. When you
have brought an end to operation, always remove the plug from the socket and
give the terrace radiator time to cool off before you move or touch it.

Safety device

The EUROM PD2100 XXL terrace radiator is equipped with a failsafe device, which
switches off the device should it fall, in spite of all safety measures. Should this
happen, immediately remove the plug from the socket and move the switch to 'off'.
Check the terrace radiator closely for damage and have the device sent for
repair/checking by your supplier or a certified electrician. Do not continue to use
the device if you notice any damage!
If you do not notice any damage, you can resume operation with care. Keep a close
eye on the terrace radiator for the first quarter of an hour to check that no
disturbances occur. If they do, immediately disconnect it and contact your supplier
or electrician.
Cleaning & maintenance
Cleaning
Before cleaning remove the plug from the power outlet and wait until the device is
sufficiently cooled off. Wipe the device only with a clean and lint-free cloth or a soft
brush. You can use a moist (not wet!) cloth with a rather mild cleaning product.
Ensure that the lamp is fully dry before you return it to operation!
Never use abrasive cleaners, scrubbing brushes and chemical cleaners for cleaning!
Never use flammable cleaners such as benzene or spirit. Give the device time to
dry before you use it again.
To protect against electrical shock and danger of life, do not immerse cord, plug or
any part of the device in water or other liquid.
19