Noise/Vibration Information; Technical Data; Declaration Of Conformity - Bosch PMF 180 E Multi Bedienungsanleitung

OBJ_BUCH-345-003.book Page 13 Monday, May 14, 2007 4:11 PM

Noise/Vibration Information

Measured values determined according to EN 60745.
Typically the A-weighted noise levels of the product
are: Sound pressure level 85 dB(A); Sound power
level 96 dB(A). Uncertainty K <1.5 dB.
Wear hearing protection!
Vibration total values (triax vector sum) determined
according to EN 60745:
Sanding: Vibration emission value a
2
tainty K<2.0 m/s ,
Cutting with plunge cut saw blade: Vibration emission
2
value a =9.9 m/s , Uncertainty K<1.5 m/s
h
Cutting with segmential saw blade: Vibration emission
2
value a =5.0 m/s , Uncertainty K<1.5 m/s
h
The vibration emission level given in
WARNING
this information sheet has been meas-
ured in accordance with a standardised test given in
EN 60745 and may be used to compare one tool with
another.
The vibration emission level will vary because of the
ways in which a power tool can be used and may
increase above the level given in this information sheet.
This could lead to a significant underestimate of expo-
sure when the tool is used regularly in such a way.
Note: To be accurate, an estimation of the level of
exposure to vibration experienced during a given period
of work should also take into account the times when
the tool is switched off and when it is running but not
actually doing the job. This may significantly reduce the
exposure level over the total working period.
2 609 000 229 • 14.5.07

Technical Data

Multi-function tool
Article number
Preselection of orbital
stroke rate
Rated power input
Output power
No-load speed n
2
=6.4 m/s , Uncer-
Oscillation angle, left/right
h
Weight according to
EPTA-Procedure 01/2003
2
,
Protection class
The values given are valid for nominal voltages [U] of
2
.
230/240 V. For lower voltage and models for specific coun-
tries, these values can vary.
Please observe the article number on the type plate of your
machine. The trade names of the individual machines may vary.

Declaration of Conformity

We declare under our sole responsibility that this prod-
uct is in conformity with the following standards or stand-
ardization documents: EN 60745 according to the
provisions of the directives 89/336/EEC, 98/37/EC.
Dr. Egbert Schneider
Senior Vice President
Engineering
26.03.2007, Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
PMF 180 E
3 603 A00 0..
W
W
rpm 15000–21000
0
°
kg
Dr. Eckerhard Strötgen
Head of Product
Certification
English | 13
180
73.5
1.4
1.0
/ II