cecotec FAST&FURIOUS 4050 X-TREME Bedienungsanleitung Seite 32

ENGLISH
will light up, indicating the high steam power level is activated.
Press the power/steam power level button whenever you wish to switch between the 3 steam
power levels.
Hold down the power/steam power level button to turn the device off.
Brush attachment
Fig. 2.
This attachment can be used in garments that require a medium-high heat and are steam-
proof. This attachment can be useful to remove lint, hair and pet hair from garments.
Fig. 3.
While the device and the attachment are cool, gently attach the top of the brush over the top
the garment steamer head and then click the bottom of the brush into place. (A)
To remove the brush attachment, gently pull on the tab. (B)
Warning: Be careful when removing the brush attachment as condensation may build up
during use.
Filling the water tank
Fig. 4.
Place the device on its base on a stable surface.
Hold the device from the handle with one hand and pull out the removable water tank with the
other hand. (C)
Gently open the tank cover at the front of the tank. (D)
Note: Using distilled, purified, or filtered water is highly recommended and will reduce mineral
buildup. Do not use oils, perfumes or scented additives.
Using a clean measuring cup, pour water into the opening until water reaches the "MAX" level
mark on the top of the tank. (E)
Do not overfill. Close the rubber cover securely.
Dry off any excess water from the tank. Push the water tank back into the garment steamer
base until it clicks into place.
To refill at any time during use, turn the garment steamer off by pressing the power/steam
power level button until the indicator light turns off, unplug from the power outlet, and follow
the above procedure.
After refilling the tank, allow the device to preheat for 45 seconds and then press the steam
trigger until steam is produced.
Continuous steam function
Fig. 5.
Connect the appliance to the power supply.
Press the power/steam power level button to turn the device on. The light indicator will flash
and the device will start preheating. Then, the light indicator will turn steady on indicating the
preheating process is over and the device is ready to use. The preheating process will take
about 35 seconds. (F)
32
FAST&FURIOUS 4050 X-TREME