Belkin N1 Vision Installationsanleitung Seite 87

Manually Configuring Network Settings
4. Select the "TCP/IP" tab (3). Next to "Configure" (4), you should see
"Manually" or "Using DHCP". If you do not, check the PPPoE tab (5) to
make sure that "Connect using PPPoE" is NOT selected. If it is, you will
need to configure your N1 Vision for a PPPoE connection type using your
user name and password.
5. If "Manually" is selected, your N1 Vision will need to be set up for a static
IP connection type. Write the address information in the table below. You
will need to enter this information into the N1 Vision.
6. If not already selected, select "Using DHCP" next to "Configure" (4),
then click "Apply Now".
Your network settings are now configured for use with the N1 Vision.
85
1
2
3
4
5
6
7
8
9
10