Kessel Aqualift S 100 Einbau- Und Betriebsanleitung Seite 25

4.2.4 Establish pressure pipe connection
KESSEL recommends using the enclosed adapter with
thread change. If this is not used, the pressure pipe connec-
tion can be bonded as follows:
Clean the bonding surfaces.
Apply PVC adhesive on the bonding surface of the
pressure pipe connection socket.
If required, push on bonded socket or adapter with
thread change (1 1/2").
If necessary, install pressure pipe after applying the
PVC adhesive.
Observe the usage instructions and drying time for the
adhesive!
4.3 Fixing the tank
Make drillholes on both sides for plugs (Ø10 mm, length
50mm ).
Insert plugs in each.
Place washer on fixing recess, then tighten the hexagon
screws.
016-227_01 25 / 100