INSTALLATION INSTRUCTIONS
Installation instructions
: Important safety information
Read these instructions carefully. Only then
will you be able to operate your appliance
safely and correctly. Retain the instruction
manual and installation instructions for
future use or for subsequent owners.
The appliance can only be used safely if it
is correctly installed according to the safety
instructions. The installer is responsible for
ensuring that the appliance works perfectly
at its installation location.
The width of the extractor hood must
correspond at least with the width of the
hob.
For the installation, observe the currently
valid building regulations and the
regulations of the local electricity and gas
suppliers.
When conveying the exhaust air, official and
legal regulations (e.g. state building
regulations) must be followed.
This appliance is installed on the wall.
■
Follow the enclosed installation instructions for additional
■
special accessories (e.g. for circulating-air mode).
The surfaces of the appliance are sensitive. Avoid damaging
■
them during installation.
Risk of death!
Risk of poisoning from flue gases that are
drawn back in. The exhaust air must not be
conveyed into a functioning smoke or
exhaust gas flue or into a shaft which is
used to ventilate installation rooms that
contain heating appliances. If the exhaust
air is to be conveyed into a non-functioning
smoke or exhaust gas flue, you must obtain
the consent of the heating engineer
responsible.
Danger of death!
Risk of poisoning from flue gases that are
drawn back in.
Always ensure adequate fresh air in the
room if the appliance is being operated in
exhaust air mode at the same time as room
air-dependent heat-producing appliance is
being operated.
21