SWM VAREZ 125 Handbuch - Gebrauch - Wartung Seite 80

ENGINE OIL AND FILTER CHANGE
Note
Carry out this operation with the engine hot.
CAUTION
Be careful not to touch the hot oil.
Remove the push rod by unscrewing the front
-
retaining screw (1) and the two rear screws (2) (one
per side).
Position the motorcycle on a flat surface in vertical
-
position.
Unscrew the plug (3).
-
Place a basin underneath the oil reservoir below the
-
drain plug (4).
Unscrew the drain plug (4) located under the oil
-
reservoir and let all the oil drain out.
Unscrew the two retaining screws (5) and remove the
-
cover (6) paying attention to the direction of removal.
2
28
EN -
Remove the filter, check its condition and replace it
-
if necessary.
Refit the drain plug (4) replacing the sealing washer
-
(tightening torque: 20 Nm - 2.0 Kgm - 14.75 ft/lb).
Refit the filter and the cover (6) and replace the
-
gasket, paying attention to respect the correct
direction of assembly.
Note
The total quantity of engine oil is 1.35 kg.
1
Pour about 1 kg of oil into the engine through the filler
-
neck (7).
Start the engine and let it run for a couple of minutes.
-
Pour in the remaining oil to top up to the correct level.
-
Refit the side plug (3).
-