EN
3.4. OPERATING THE EMERGENCY CRANK
Never use the emergency crank when a control point is
not programmed in the motor.
Never lower the awning below the broken arm position
using the crank.
-
Check that the mains power supply is off.
Hook the Somfy emergency crank into the crank handle.
-
Turn the crank to raise or lower the awning.
-
3.5. OPERATING WITH A SOMFY SUN SENSOR
Refer to the corresponding guide.
3.6. ADDITIONAL SETTINGS
3.6.1. Programming or modifying the favourite position (my)
Place the motorised product in the desired favourite
1)
position (my).
Press my
2)
up and down: the desired favourite position (my) has been
programmed.
3.6.2. Deleting the favourite position (my)
1) Press my: the motorised product starts to move, and stops
in the favourite position (my).
2) Press my again until the motorised product moves: the
favourite position (my) is deleted.
3.6.3. Adding/Deleting Somfy control points and sensors
Refer to the corresponding guide.
3.7. OPERATING AFTER A POWER CUT
for less than 2 minutes. Above this time, the motor switches to end limit reinitialisation mode.
To return to the standard operating mode, one of the following 3 operations must be performed.
Use of the Up button
operating mode.
Use of the Down button
at torque detection then lowed until the lower end limit and a return standard operating mode.
Appearance of wind
When the wind speed exceeds the threshold set on the wind sensor, a raise order is sent to the
motor. The awning is raised to the upper end limit and returns to standard operating mode.
22
Images not contractually binding
motorised product moves
Copyright © 2014-2018 Somfy Activités SA, Société Anonyme. All rights reserved.
OFF
1
2
or
my
1
2
my