Maintenance; Environmental Protection - Ryobi R18SS4 Übersetzung Der Originalanleitung

2. Switch off
3. Battery port
4. Dust vacuum adapter
5. Paper clamp
6. Cushion
7. Lever
8. Dust bag
9. Sandpaper (80 grit)
10. Sandpaper (120 grit)
11. Sandpaper (220 grit)

MAINTENANCE

WARNING
Empty bag frequently and before storage to avoid
possible fi re hazard due to self-ignition of the dust.
WARNING
The product should never be connected to a power
supply when you are assembling parts, cleaning,
performing maintenance, or when the product is not in
use. Disconnecting the product will prevent accidental
starting that could cause serious injury.
WARNING
When servicing, use only identical Ryobi replacement
parts. Use of any other parts may create a hazard or
cause product damage.
WARNING
Always remove the sanding sheet from the product
before cleaning. Failure to do so could cause serious
personal injury.
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to various types of commercial
solvents and may be damaged by their use. Use clean
cloths to remove dirt, carbon dust, etc.
WARNING
Do not at any time let brake fl uids, gasoline, petroleum-
based products, penetrating oils, etc. come in contact
with plastic parts. They contain chemicals that can
damage, weaken or destroy plastic.
Electric tools used on fi berglass material, wallboard,
spackling compounds, or plaster are subject to accelerated
wear and possible premature failure because the fi berglass
chips and grindings are highly abrasive to bearings,
brushes and commutators. The manufacturer does not
recommend the use of the product for extended periods of
time on these types of materials.
After each use, remove the sanding sheet and dust
collector if fi tted. Clean the dust collector as shown in the
2 | English
illustrations in this manual. Clean the tool thoroughly with a
brush, dry cloth and vacuum cleaner.
WARNING
Do not use compressed air to blow dust from the product
to prevent serious eye injury.
For greater safety and reliability, all repairs should be
performed by an authorised Ryobi service centre.
All of the bearings in this tool are lubricated with a suffi cient
amount of high grade lubricant for the life of the unit
under normal operating conditions. Therefore, no further
lubrication is required.

ENVIRONMENTAL PROTECTION

Recycle raw materials instead of disposing
of as waste. The machine, accessories and
packaging should be sorted for environmental-
friendly recycling.
SYMBOLS
Safety Alert
V Volts
No-load speed
min‫¹־‬ Revolutions or reciprocations per minute
Direct current
CE Conformity
EurAsian Conformity Mark.
Ukrainian mark of conformity
Please read the instructions carefully before
starting the machine.
Wear ear protection
Wear eye protection