Maintenance; Environmental Protection - Ryobi R18B Übersetzung Der Originalanleitung

kNoW youR pRoduct
See page 67.
1. Battery port
2. On/off switch
3. Handle, insulated gripping surface
4. Rotating base
5. Application bonnet
6. Buffing/polishing bonnet

MAINtENANcE

WARNING
The product should never be connected to a power
supply when assembling parts, making adjustments,
cleaning, performing maintenance, or when the product
is not in use. Disconnecting the product from the power
supply will prevent accidental starting that could cause
serious injury.
WARNING
When servicing, use only original manufacturer's
replacement parts, accessories and attachments. Use of
any other parts may create a hazard or cause product
damage.
Avoid using solvents when cleaning plastic parts. Most
■
plastics are susceptible to various types of commercial
solvents and may be damaged by their use. Use clean
cloths to remove dirt, carbon dust, etc.
WARNING
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal
injury.
WARNING
For greater safety and reliability, all repairs should be
performed by an authorised service centre.
ApplIcAtIoN ANd BuffING/polIshING BoNNEts
Both the application and buffing/polishing bonnets are
■
reusable. For maximum life and performance, hand
wash after use and allow them to air dry. If needed, the
bonnets can be machine washed in cold water with a
small amount of detergent, then machine dried using
low heat.
foAM pAd
It is important that the pad retain its original shape and
■
dimensions. Allow it to dry completely after each use.
Make sure to remove the bonnets, wash them, and
2
store separately. The product should be stored with the
pad facing up in order to extend pad life and retain its
shape. Be careful not to use too much polish at one
time. If the pad becomes saturated, it will not last as
long.

ENvIRoNMENtAl pRotEctIoN

Recycle raw materials instead of disposing
of as waste. The machine, accessories
and packaging should be sorted for
environmental-friendly recycling.
syMBols
Safety alert
No-load speed
Diameter
CE conformity
EurAsian Conformity Mark
Ukrainian mark of conformity
Please read the instructions carefully
before starting the machine.
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your local authority or
retailer for recycling advice.
English