General Notes - Spartherm R1V51 Aufbauanleitung

1. GENERAL NOTES

THESE INSTALLATION INSTRUCTIONS COMPLY WITH THE
SPECIFICATIONS IN DIN EN 13229 „FIREPLACES FOR SOLID FUEL."
You must also comply with national and regional specifications,
standards, installation methods, and materials. Our fireplace
inserts are for temporary fires and not for permanent heating.
This means that the fire will burn as long as wood continues to
be added to it.
Of course our fireplace inserts are subject to our company quality
criteria – from incoming shipment inspection to shipment release.
Young children, older or infirm adults:
As with all heaters, it makes sense to set up a protective device
for this group of people because the viewing pane and the facing
panels of the fireplace unit can become extremely hot.
Risk of burning!
Never leave this group of people near an active or recently extin-
guished fireplace insert without supervision. Inform this group of
people that the fireplace insert is a source of potential danger.
Do not place or lay any combustible objects on the exposed surfaces
of the fireplace unit. Do not place any pieces of clothing on the
installation's heating tiles in order to dry them. Set up a laundry rack
for drying clothing outside the area of radiation only!
The burning process releases heat energy that leads to the fire-
place unit (surfaces, door handles and operating knobs, viewing
pane, etc.). Do not touch or operate the active fireplace unit wit-
hout suitable protection (e.g. the heat-resistant glove included).
Do not make any modifications to the fireplace insert. In particular,
do not place any mounting parts in the combustion chamber, flue
or vent if these parts are not approved by Spartherm. Without
express permission, any modification or change in the fireplace will
render the guarantee and operating permit invalid.
Exhaust hoods, ventilation systems, etc. that are installed in the
same room or ambient air network as fireplaces may adversely
affect the functioning of the fireplace insert (including allowing
smoke to escape into a room) and require suitable measures
before they can be operated at the same time as the fireplace.
If several fireplaces are being operated in a room or an ambient
air network, make sure that the combustion air supply is adequate.
This is a fireplace for temporary fires. The fireplace can only be
used for heating by repeatedly adding wood to it and not removing
the combustion air.
TRANSPORT DAMAGE: Inspect this product upon delivery (visual
check). Be sure to note any damage on the delivery slip. Then
inform your fireplace fitter. Protect the viewing pane of your fire-
place insert against dirt and damage while the facing is being
installed.
The TECHNICAL SPECIFICATIONS
page 17.
GB 4
for your fireplace insert start on