Mounting The Conduit Cable - Magnescale GB-ER Serie Handbuch

c
Use a spanner on
parts A and B to
3/4 of a
revolution
turn in the direction
of the arrow.
Part B
Female side
Fig. 3-17
Note
• Use a wrench or other tool to tighten the connectors to a torque
of 150 to 250 N·cm. Waterproof performance cannot be
guaranteed unless the connectors are tightened to the specified
torque.
• Do not tighten the connectors by attaching wrenches to parts A
and C.
To remove
Use a spanner on parts
A and C to turn in the
direction of the arrow.
Part B
Female side
Fig. 3-18
Note
Do not loosen the connectors by attaching wrenches to parts A
and B.
Part C
Male side
Part A
Male side
Part C
Part A
<8> Mounting the conduit cable
Fix the conduit cable with cable clamps so that they will not
interfere with moving parts of the machine.
Note
Care should be taken at this time as it may be necessary to
provide the cable with some leeway with respect to the machine
operation.
Secure the cable clamp using a M4 × 10 cable
clamp screw (accessory).
Fig. 3-19
21
(E)