Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Remove the fastening screws
cross-tip screwdriver. Then open the battery
cover on the solar cell housing
flat-head screwdriver.
Replace the old battery
chargeable battery, taking care not to damage
the cables. Please note the polarity when in-
serting the battery. This is shown inside the bat-
tery compartment
batteries of the recommended type (see
„Technical data").
Close the battery cover and tighten the retaining
screws
using a small cross-tip screwdriver.
8
Set the ON/OFF switch
Reattach the solar cell housing
shade
. Then assemble the remaining parts
1
of the lamp.
Charging
Please note, the solar garden light must be switched
on when the battery is charging. The charging time
via the solar cell varies by the intensity of the sunlight
and the incidence angle of light onto the solar cell.
Place the solar cell as perpendicular as possible to
incidence angle of light. This will ensure the brightest
light.
Maintenance and cleaning
The LEDs cannot be replaced. The solar lamp is
maintenance-free, except for any necessary change
of battery.
Routinely clean the solar light with a dry, lint-
free cloth. Use a slightly moist cloth if very dirty.
Troubleshooting
Note: The device contains sensitive electronic
components. Radio transmitting equipment in the
immediate vicinity may therefore cause interfer-
ence. If you notice the device is malfunctioning,
using a small
8
using a
2
with a new re-
10
. Use only rechargeable
9
to the „ON" position.
7
to the lamp
2
remove any sources of interference from the area
around the device.
Note: Electrostatic discharge can cause malfunc-
tions. In the event of such malfunctions, briefly
remove and reinsert the rechargeable batteries.
Error
Cause
The light will not
Artificial sourc-
switch on even
es of light, e.g.
though the sun
street lighting,
shone on the
is interfering
lamp all day.
with the light.
The light does
The rechargea-
not come on or
ble battery is
comes on only
broken or the-
briefly.
re was not
enough day-
light.
Disposal
The packaging is made entirely of recyclable materials,
which you may dispose of at local recycling facilities.
Observe the marking of the packaging
materials for waste separation, which
b
a
are marked with abbreviations (a) and
numbers (b) with following meaning:
1–7: plastics / 20–22: paper and fibre-
board / 80–98: composite materials.
The product and packaging materials
are recyclable, dispose of it separately
for better waste treatment. The Triman
logo is valid in France only.
Contact your local refuse disposal
authority for more details of how to
dispose of your worn-out product.
Do not dispose of electrical
equipment in the household
waste!
Solution
Place the light in
a location where
it will not be af-
fected by other
light sources.
Replace the bat-
tery or install the
light in a location
where it has gre-
ater exposure to
sunlight.
GB/IE
17
Werbung
Inhaltsverzeichnis
