User Instructions; Installation; Functions - Fulgor Milano FCLH 9008 ID WT Installation, Gebrauch, Wartung

3 - User instructions

EN

Installation

All operations relating to installation (electrical connection)
must be performed by qualified personnel in accordance with
the current regulations.
For specific instructions, see the section reserved for the installer
IMPORTANT
DO NOT LOOK AT THE LEDS AND DISPLAYS INTENSELY.

Functions

All functions can be performed using the ON/OFF button, the
display area and the "back" button. Information and feedback
are provided by the graphic display.
Touch Control on/offl
After applying power, the touch control takes a second to be
ready. After a reset, all the LEDs light up for one second. After
this time all the LEDs go off again. The interface can now be
started by touching the on/off button. The logo appears on the
display for 2 seconds, followed by a safety warning sign. Do
not place hot pans on the display.
Button
ON/OFF
The cooking mode is then active. The display shows all the
cooking zones. The electronics will remain active for 20
seconds.
If no action is taken within this time (zone or timer selection),
the hob goes into standby, indicated by an acoustic signal.
The induction hob only switches on if the on/off button is
pressed. If another button is recognised, the hob will not turn
on.
Manual switching off of the hob takes place by keeping the
on/off key pressed.
6
Display area
Button
"INDIETRO/BACK"
Automatic switch off
The hob changes from switching on to switching off after 20
sec. if no cooking zone is activated or the multifunction button
is pressed during this time.
Switching a cooking zone on/off
If the control is already on, it is possible to select a zone
by touching one of the cooking zones on the display. After
selecting the cooking zones, the cooking level can be adjusted
by touching the slider area. By "sliding" your finger on the
slider area it is possible to increase or decrease the cooking
level (0 - P). Alternatively, the cooking level can be selected
directly on the slider without sliding. If the cooking level is set
to 0 the cooking zone is in "off" mode.
Switching off all the cooking zones
Immediate switching off of all the cooking zones is always
possible by pressing and holding the on/off key. Even if the
Touch Control is locked, switching off is possible. All cooking
zones that have the "hot" status have a circle with three rings.
Automatic switch-off (operating time limitation)
Depending on the cooking level chosen, a maximum operating
time limit is defined (if no cooking level changes are made).
If this maximum operating time is exceeded on a cooking
zone, it is switched off. If the surface is hot, the residual heat is
displayed. After each user operation, the time remaining until
automatic switch off is reset to the defined operating time limit
of this cooking level.
The timer settings have priority over the operating time
limitation. The detailed operating time according to the power
level can be ascertained from the table.