Renkforce CD-7657 Bedienungsanleitung Seite 57

Operation
• AF button (5)
The AF button (5) activates the automatic transmitter station tracking.
„AF" will be displayed. If the reception of an RDS transmitter station gets weaker or the radio does not receive and
RDS station at all, the display flashes. When a station can be received well, the symbol is displayed continuously.
When an RDS station is being received, the name of the station is displayed.
When you leave a transmission area, the radio can only switch to a station with better reception when the AF function
is activated.
Regional identification
Press the AF button (5) for about 2 seconds until the display shows REG ON or REG OFF. Press the AF button again
to switch between these two operating modes. The normal display reappears automatically after a few seconds.
If REG ON is on and the reception gets weaker, the radio only switches to a different frequency with exactly the same
program.
When the regional identification is off (REG OFF), and the reception gets weaker, the radio switches to a different
transmitter station with the same regional identification.
• TA button (6)
Press the TA button (6) once shortly >
Press the button again
When you receive a traffic programme station, the display shows TP (traffic programme).
When you keep the TA button pressed, TA is displayed. Now you can only receive stations with a traffic programme.
If a different audio source is being played (a CD for instance), the programme is set to mute during the traffic
announcement.
When you listen to a radio program at a very low volume, the volume is automatically increased to an easily audible
level (see TAVOL in the „Menu settings"). When the traffic announcement is over, the volume you were hearing before
is restored.
Depending on whether you have set TA SEEK or TA ALARM (see "Menu Settings") the radio automatically seeks
a new traffic programme station or gives an alarm signal.
TA is activated
> TA is deactivated.
57