Fitting Instructions For Doors That Open Inwards - Abus PR2800 Montage- Und Bedienungsanleitung

VI. Fitting instructions for doors that open inwards
Please verify that the PR2800 fits onto the door panel for two-speed locked door bars
before carrying out the fitting steps described below.
Lock the door bar directly into the brickwork in the narrow niche area (use PWA2700 if
necessary -> see under special accessories, page 14).
Fitting the lock body
1. Remove the safety screws. ATTENTION: The sliding casing may fall down
2. Set and mark the position of the lock body on the door panel (Fig. 3 + 4).
Mark a hole Ø 53–58 mm in the middle accordingly (Fig. 10) and drill with a milling
cutter/hole saw from both sides.
Fig. 10
½
3. Mount the lock body, attach the escutcheon and door exterior (Fig. 11).
4. Align the lock body horizontally, move the sliding casing according to the door panel
width (30-40 mm from the door panel edge) (Fig. 12a).
5. Pre-drill the position of the mounting screws (wood Ø 3.0 mm/metal Ø 3.5 mm)
and tighten the lock body with screws Ø 4.2 x 22 mm.
NOTE: If the lock body mounting does not provide sufficient support, additional screws
with 4.2 x 22 mm or 4 x 35 mm or the external escutcheon PR2800 with an all-through
screw fitting can be used (Fig. 31).
Fig. 12
½
Ø 53–58 mm
Fig. 11
Fig. 12a
30 - 40 mm
Fig. 13
73
GB