MBM FRBE74T Installations- Und Bedienungsanleitung Seite 27

Every technical change has
an effect on the operation or
safety of the appliance and
must therefore be performed by te-
chnical personnel of the manufactu-
rer or by technicians who are formal-
ly authorised by the same. Failure to
do so exempts the manufacturer
from any liability for for any possible
resulting modifications or damage.
Upon arrival, check the integri-
ty of the appliance and its com-
ponents (e.g. power cord), pri-
or to use. In the presence of faults
do not start the appliance and con-
tact the nearest service centre.
Read the instructions before
acting.
tions to be performed. As far as per-
sonal protective
concerned, the European Commu-
nity has issued Directives which the
operators must comply with. Noise
≤ 70 dB.
It is forbidden the installa-
tion of stand alone equip-
ment WITHOUT anti-tip kit
(ACCESSORY). TOP versions
excluded.
Before making
nections check the technical
data shown on the rating plate
of the appliance and the technical
data in this manual. It is strictly for-
bidden to tamper with or remove
the plates and pictograms applied
to the equipment.
Disconnect all supplies, if
present (e.g. water - gas -
electrical) upstream the appli-
ance whenever you need to work in
safe conditions.
THE PRESENT MANUAL IS PROPERTY OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
GENERAL AND SAFETY INFORMATION
Wear protective
equipment suita-
ble for the opera-
equipment
the con-
- 5 -
Connect the appliance if pre-
sent, in the sequence of the
water, then to the gas network. En-
sure there are no leaks then proce-
ed with the connections to the mains.
The appliance is not designed
to work in an explosive atmo-
sphere and as such its instal-
lation and use is categorically prohi-
bited in such environments.
Position the entire structure,
respecting the installation di-
mensions and characteristics
indicated in the specific chapters of
this manual.
The appliance is not intended
for recessed installation. / The
appliance must be used in a
well ventilated area. / The appliance
must have free drainage (not hinde-
red or impeded by foreign bodies).
is
The gas equipment must be
installed beneath an extrac-
tion hood whose system must
have specifications in compliance
with the current regulations in the
country of use.
Once the appliance is con-
nected to the power and drain
sources, it must remain static
(fixed) in the place of use and main-
tenance. Incorrect connection may
cause danger.
Use where appropriate flexi-
ble cable for connection to the
mains electricity supply with
characteristics not inferior to the
model H07RN-F. The supply volta-
ge supported by the cable with the
appliance working must not differ
from the nominal voltage value ±
15% shown at the bottom of the te-
chnical data table.
2.
EN