Quick Start Guide - Coboc Brooklyn FAT Bedienungsanleitung

40
SCOPE OF DELIVERY
• Coboc Brooklyn FAT •
• battery charger •
• Coboc URB pedals •
• hex socket key
SET-UP
Coboc e-bikes are almost completely assembled at the point of delivery. However,
handlebar and pedals are loosened for transport, which is why, prior to your first
ride, you must bear in mind the user manual while taking the following steps. Par-
ticularly take into consideration the safety instructions and the indicated tightening
torque for screw fittings (s. chapter Maintenance & Care such as Tightening torque).
Checking tire pressure
Check for tire pressure before the start of every journey. The correct pressure
is given on the side of the tire and can differ depending on the tire model. The
minimum or maximum prescribed tire pressure for your Coboc bike must not
be fallen below or exceeded. You can find information about this on the side of
your tire's sidewall. Driving with too little air pressure can damage the rim and
the tire.
Screwing on pedals
Lightly grease the pedal threads before screwing them into the intended cranks (5).
Both pedals have different threads and need to be screwed in at the
intended side. The right pedal has a right-handed thread, while the left
pedal has a left-handed thread. Mixing them up may lead to damaged
crank arms or pedal threads. Make sure both pedals are tightened.
(5)

Quick Start Guide

user manual
reflector set with bicycle bell
frame protection film
Aligning handlebar and stem
First loosen both screws (1). The fitting hex socket key is included with delivery.
Align the handlebar in a way that stem and front wheel are in line with each
other. Now tighten screws (1) again. Afterwards loosen the four screws in the
stem (3). Turn the handlebar into desired driving position and tighten screws
afterwards. Make sure that you tighten all four screws (3) equally.
Adjusting brake levers
Loosen the clamp screws (4) and adjust the brake lever according to your
preferred grip position. It should be comfortable and safe at the same time.
Afterwards tighten the clamp screws (4) again.
Setting headset bearing
Check if the headset bearing has play. To do that, you must pull the front brake
while pushing your e-bike back and forth a couple of times. The handlebar
should be able to slightly move from left to right, while bearing clearance should
stay at a minimum. If there is bearing clearance, again loosen both screws (1)
and slowly tighten screw (2) until the bearing has no play anymore. Afterwards
tighten both screws (1) again.
Do not tighten screw (2) too much, as this may lead to a damaged
headset bearing. If the handlebar only turns with effort, then this could
mean that screw (2) has been tightened too much. If this is the case,
loosen screws (1) in order to slightly loosen screw (2). Afterwards tighten both
screws (1) again.
(4)
(3)
(2)
(1)