Establishing The Electric Connection; Removing The Transport Protection - Ivoclar digital PrograMill Dry Bedienungsanleitung

PrograMill Dry – Installing the machine

Establishing the electric connection

NOTICE
Damaging of the machine through heavy voltage
fluctuations and power surges
Heavy voltage fluctuations and power surges can
disrupt the control unit and can cause system failures.
Connect the machine to a dedicated current circuit
or ensure that no devices are connected that can
cause heavy voltage fluctuation when switched on.
If heavy voltage fluctuations cannot be avoided,
install a surge protector that protects the machine
from heavy voltage fluctuations.
NOTICE
Short-circuit hazard when the machine is too cold
If the machine is transported from a cold environment
into a warmer environment, a short circuit may occur
caused by condensate.
Before switching on the machine after trans-
portation, ensure the following:
The ambient air has the allowed temperature.
n
The machine has the same temperature as the
n
ambient air. This will take at least 48 hours.
The machine is completely dry.
n
The machine requires a continuous power supply for
proper operation.
1. Plug the provided power cable into the power con-
nection at the connection panel of the machine.
2. If power failures occur regularly at the installation
location or if there are frequent voltage fluc-
tuations, install an Uninterruptible Power Supply
(UPS).
If a power failure occurs during job execu-
tion, the tool may break and the material
may be destroyed.
3. Insert the plug of the cable into a socket that is pro-
tected by a Residual Current Device / Ground
Fault Circuit Interrupter.

Removing the transport protection

Before operating the machine for the first time, you
must remove the transport lock. The transport lock
prevents the spindle from getting damaged during
transport.
Operating Instructions: PrograMill Dry
Version: 2/19/2021
1. Ensure the following:
The machine is connected to the electrical
n
source.
The CNC computer
n
machine.
2. Switch on the machine at the main power switch.
3. Open the working chamber door.
4. Switch off the machine at the main power switch.
You can now move the axes of the machine.
5. Remove the transport lock as shown in the sup-
plement.
EN 15
is not connected to the