Climate Operation; Manual Climate Operation, Quick-Start - Sentiotec Sawo CK31 Montageanweisung, Gebrauchsanweisung

Climate operation

8 Manual operation, quick-start
8.1 Switching on the sauna control
1. Press ON/OFF 1.
- The LEDs C - F light up for approx. 5 seconds.
- The LED of the previously selected bath, SAUNA
H or CLIMATE A lights up.
- The display 6 indicates the current time
(e.g.16:30 hours):
16:30
8.2 Setting to climate operation
1. Press Climate button A.
The LED of the Climate button A lights up and
LED of the Sauna button H goes out.
The LEDs C - F light up for approx. 5 seconds.
-
- The display 6 then indicates the current time.
2. Press START / STOP 7.
The heater starts instantly at the preprogrammed tem-
perature of 50° C or at the previously set temperatu-
re. The heating process starts immediately.
50
Operating instructions for the user 9
Climate operation
8 Manual operation, quick-start
Continued
8.3 Entering the heating duration (00:00 -
6:00)
1. Press UP/DOWN buttons 8 until the LED TIME
E lights up:
The display 6 indicates:
STOP
if the control has not been started yet.
2. Press PROG/OK 9:
The display 6 flashes:
06.00
or the value set previously.
3. Use the UP/DOWN buttons 8 to enter the desired
value, e.g. [02:30].
The display 6 flashes:
02:30
4. Press PROG/OK 9:
The display 6 indicates:
STOP
in standby or
02:30
if the heating duration was changed while in he-
ating operation.
The heating duration has been set.