Change Grinding Disc; Change Dry Grinding Disc - Parkside PNTS 250 C2 Originalbetriebsanleitung

Change grinding disc

Information
on replacement:
- Never operate the device without
protective equipment.
- Ensure that the rotation speed stated
on the grinding disc is the same or
higher than the nominal rotation
speed of the device.
- Ensure that the grinding disc dimen-
sions match those of the device.
- Only use flawless grinding discs.
Perform a ringing test. When strik-
ing the grinding disk with a plastic
hammer, this should result in a clear
sound.
- Never re-drill a locating hole which is
too small to make it larger.
- Never use separate bushings or
adapters in order to make grinding
discs whose hole is too large fit the
device.
- Do not use any saw blades.
- To clamp the grinding tools only use
the clamping flange provided. The
pads between the clamping flange
and the grinding tools must be made
of elastic materials e.g., rubber, soft
cardboard etc.
- Always reassemble the device com-
pletely after replacing the grinding
disc.
Switch the device off and remove
the mains plug.
Allow the device to cool down.
Wear protective gloves when
changing the grinding discs in or-
der to avoid cutting damages.

Change dry grinding disc:

1. Remove the spark protection (
2) (see „Assemble/adjust
spark protection").
2. Loosen the fixing screws and re-
move the dry grinding disc cover
( 4) from the protective hood
(25).
3. Unscrew the grinding disc
nut (22) with a screw wrench
(AF 19 mm) and hold against
the grinding disc with one hand
wearing a glove.
Unscrew the nut (right-hand
thread): turn counter-clockwise.
4. Remove the clamping flange (23)
and the dry grinding disc (5)
together with the two cardboard
intermediate layers (24).
5. Fit on the new dry grinding disc
(5) with the intermediate card-
board layers (24) and the clamp-
ing flange (23), and screw the
grinding disc nut (22) manually
onto the nut (right-hand thread):
turn clockwise.
6. Tighten the grinding disc nut
with a screw wrench (AF 19 mm)
applying modest manual force.
7. Screw the dry grinding disc
cover (4).
8. Adjust the spark protection hold-
er ( 18) and the workpiece
support (
from the dry grinding wheel (5)
must not exceed 2 mm (see „As-
sembly").
The grinding disc nut must not be
screwed too tightly in order to
avoid a breaking of the grinding
disc and nut.
GB IE
6) - The distance
31