Troubleshooting - Topcom Twintalker 9500 Airsoft Edition Bedienungsanleitung

10
Dual Channel Monitor (DCM) allows you to monitor a second channel
with CTCSS/DCS code.
• Press the
DCM OFF" will flash on the display.
• Press the
button
• Press the
channel selection and go to CTCSS
selection. (Press the
again to go to DCS selection)
• Press the
button
DCS code.
• Press the
and return to stand-by mode.
• To disable the function select "OFF" when
selecting the DCM channel.
When the Dual Channel Monitor function is activated, the PMR will switch
sequentially between the standby channel + CTCSS/DCS code and the
Dual Channel + CTCSS/DCS code.
13.15 Button Lock
• Press and hold the
three seconds to activate the Button lock
mode. The button lock icon is displayed on
the LCD Screen.
• Press and hold the
for three seconds deactivate button lock
12
PTT
The -button
1
button will still be functional when the Button Lock
is activated.
7
-button twelve times,"
11
-button or the
10
to change the channel.
7
-button to confirm the
-button
11
-button or the
10
to change the CTCSS code or
12
PTT -button to confirm
7
-button
7
-button
6
, the -button and the
13.16 Display back light
To activate the backlight of the LCD display, press any button except the
PTT - button
The LCD backlight will light up for 6 seconds.
14 Earpiece connection
-
The connector is located on the upper side of the unit
Insert the earpiece plug into the connector (2,5mm jack).
The small button on the earpiece has the same function as the
12
button
7
When you use the
use the microphone from the earpiece to talk into
-
Do not connect other earpieces. This may damage your
device.

15 Troubleshooting

No power
No transmission
No reception
for
Limited Range and
again
noice during
transmission
-
6
12
or the button .
on the unit
12
PTT
- button from the Earpiece, you must also
Clean the battery contacts with a soft cloth.
Replace the batteries.
Make sure the PTT - button
completely before you speak.
Monitor the channel activity and switch to another
channel if the current is used.
Check the speaker volume.
Make sure that you are in the reception range of
the sender and change if necessary your
location.
The talking range depends on the terrain.
Steal constructions, concrete buildings or the use
in vehicles have a bad influence on the range.
Try to avoid as many obstacles as possible and
communicate in a clear line of sight.
Change your locations.
Twintalker 9500 Airsoft Edition
.
2
PTT
-
.
12
is pressed