Front Panel Description; Figure 2 - Agilent Technologies Turbo-V 81-AG Bedienungshandbuch

Front Panel Description

Figure 2

1 Keyboard push-button to recall on the display the cycle number, cycle time and pump life.
2 Keyboard push-button for LOW SPEED mode selection. It is active only when the front
panel operation has been selected. Pressed once, the pump runs at "stand-by" speed. To
unselect the mode, press the push-button again.
3 Keyboard push-button to recall on the display the pump current, pump temperature, pump
power and rotational speed. It is always active regardless of the operating mode selected.
Push-buttons 3 and 1, if pressed together for at least 2 seconds, put the controller in a
routine where it is possible to program some operation parameters.
4 Keyboard push-button for START, STOP/RESET mode selection. It is active only when the
front panel operation has been selected. By pressing once the starting phase begins; if
pressed again it stops the pump. If the pump has been stopped automatically by a fault, this
push-button must be pressed once to reset the controller and a second time to restart the pump
5 LCD back-lighted alphanumeric display: dot matrix 2 lines x 16 characters.
Turbo-V 81-AG Rack Controller User Manual / 87-900-986-01
5
LS
AG
1
VACUUM TECHNOLOGIES
COUNTERS
increase
2
decrease
LOW SPEED
Controller Turbo-V 81-AG Front Panel
Instructions for Use
R1
R2
MEASURES
next
menu
previous
START/STOP
Turbo-V 81-AG
(I)
16
Use
3
4
201/306