Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ASSEMBLY
Unpacking the machine
Take the machine components from the packing and check them in accordance with the following list.
1.
16 mm drill chuck with key
2.
Adapter MK3/B18
3.
Handle knob with bars (3)
4.
Riser handle
5.
Locking handle
Assemble the machine as shown in the figure.
1.
Set the column onto the base (1) and fasten it
using the screws and washers.
2.
Mount the column flange (2) together with the
inserted rack (3) on the column. Install the riser
handle (4) and secure it with the screw. Observe
the note.
3.
Mount the ring (5) and secure it with the screws.
4.
Mount the work table (6) on the flange (2).
5.
Screw in the locking lever (7).
6.
Set the head (8) onto the column and align it
correctly with the base. Tighten the screws.
7.
Install the feed levers (9).
8.
Install chip guard (10).
Note for item 2
After having installed the flange, please remove the screw;
it is only required to facilitate the assembly.
Remove this screw
6.
Locking handle
7.
Handle knob
8.
Screw with lock washer (3)
9.
Allen key
9
10
7
6
1
8
5
3
2
4
7
Werbung
Inhaltsverzeichnis
