Data Logger Operation Modes And Displays; A) Operation Modes And Settings - VOLTCRAFT Lux DL-230L Bedienungsanleitung

13. Data logger operation modes and displays

a) Operation modes and settings

To make the configuration easier, 13 common operation modes are listed here. To make the following configuration
settings, refer to chapter "12 b) Measurement - basic settings".
Mode 1
Feature
Setting
Mode 2
Feature
Setting
Mode 3
Feature
Setting
Mode 4
Feature
Setting
Mode 5
Feature
Setting
Logging starts immediately.
Logging stops when memory is full.
• As "Logging start condition", select: "Immediately after memory is full"
Logging starts immediately.
The logging will stop if you press and hold down the "ENTER" button (8) for a few
seconds.
• As "Logging start condition", select: "Immediately after memory is full"
• As "Logging end condition", select: "Stop button"
Logging starts immediately.
Logging stops after PDF report is generated.
• As "Logging start condition", select: "Immediately after memory is full"
• As "Logging end condition", select: "After PDF creation"
The logging will start if you press and hold down the "ENTER" button (8) for a few
seconds.
Logging stops when memory is full.
• As "Logging start condition", select: "Start upon keypress"
The logging will start and stop if you press and hold down the "ENTER" button (8) for a
few seconds.
• As "Logging start condition", select: "Start upon keypress"
• As "Logging end condition", select: "Stop button"
49