Sound Mode; Display Information - JVC BoomBlaster RV-NB100B Bedienungsanleitung

Sound mode

Sound modes can be selected to enhance the type
of music being played.
Press [SOUND MODE] to select the sound
mode.
Each time you press the button, the sound mode
changes as follows:
"BEAT" : Select this for music with a heavy
beat, such as rock and dance music.
"POP" : Select this for light music including
popular and vocal music.
"CLEAR" : Select this for crisp and clear
sounding music.
"USER" : Select this for music with the
configured treble and bass settings.
Refer to the following for the setting
procedures.
"FLAT" : Select this to cancel the sound
mode.
NOTE
The sound mode setting also affects the sound
0
through the headphones.
To set your preferred sound quality
Press [TREBLE+/-] or [BASS+/-] repeatedly.
Each time you press the button, the bass/treble can
be adjusted in the following ranges:
Treble : TREBLE -5 to TREBLE +5
Bass : BASS -5 to BASS +5
The sound mode switches to "USER" and the
0
sound quality is adjusted to the configured
values when the [TREBLE+/-] or [BASS+/-]
button is pressed.
/
Auto power save mode
This function turns off the System automatically if
no operation is performed for about 15 minutes.
Each time you press [A.P.S.], the auto power save
function switches on and off.
This function is on at the initial setting.
A.P.S.
Approximately 30 seconds before the power is
turned off, "A.P.S." starts to blink.
The System will not turn off automatically in any of
the following conditions:
"CD", "USB", or "METRONOME" is selected as
0
the source, and playback is in progress or in
pause mode.
"FM" is selected as the source.
0
"DAB" is selected as the source, and a broadcast
0
is received.
"iPod" or "BLUETOOTH" is selected as the
0
source, and a device is connected.
"AUDIO IN" is selected as the source, and there
0
is sound input.
Recording is in progress.
0
When a microphone or guitar is connected.
0
NOTE
The 15-minute countdown restarts when you
0
operate any buttons.
This function operates even during daily timer
0
and sleep timer operations.
The System turns off automatically when the
0
volume level is set to "MIN" or when the sound is
muted even if a microphone or guitar is
connected. However, the System will not turn off
automatically while recording is in progress.

Display information

Each time you press the button, the display
information switches depending on the source.
Tag information is shown on the display window
0
while an MP3/WMA file is played back.
If there is no tag information, "UNKNOWN" is
0
displayed.
"iPod" cannot show the track information.
0
13