Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2
General safety instructions | Rexroth PSG xxxx
Project engineering, programming, start and operation as well as
•
the modification of program parameters is reserved to properly
trained skilled personnel! This personnel must be able to judge
potential hazards arising from programming, program changes
and in general from the mechanical, electrical, or electronic
equipment.
Interventions in the hardware and software of our products,
•
unless described otherwise in the related documentation, are
reserved to our specialized personnel.
Our written approval is required with respect to other persons!
Only skilled personnel who are familiar with the contents of the
•
relevant documentation may install, operate and service the
products described. Such personnel are
– those who, being well trained and experienced in their field and
familiar with the relevant norms, are able to analyze the jobs
being carried out, recognize any hazards which may have arisen
and take suitable safety measures.
– those who have acquired the same amount of expert knowledge
through years of experience that would normally be acquired
through formal technical training.
Please note our comprehensive range of training courses for
personnel qualification!
For the latest information on training courses, teachware and
training systems please refer to
www.boschrexroth.com/training
For more information, you may also contact
Bosch Rexroth AG
Berliner Strasse 25
64711 Erbach
Tel. +49 (0) 6062 78-0
General safety instructions
Please not the applicable accident prevention and environmental
protection provisions.
Please note the safety instructions and regulations of the country
where the product is used/applied.
Use our products in technically perfect condition only.
Please note all information on the product.
Persons who assemble, operate, disassemble or service our
products must not be under the influence of alcohol, other drugs or
medication influencing the responsiveness.
Use approved accessories and spare parts only to rule out
hazards to persons caused by unsuitable spare parts.
Observe the technical data and environmental conditions specified
in the product documentation (see Operating Instructions for the
product).
If unsuitable products are built into or used in safety-relevant
applications, unintended operating conditions may occur in the
application which may cause physical injury and/or damage to
property. Therefore only use a product in safety-relevant
applications if this use is expressly specified and permitted in the
product documentation.
You may only commission our product after establishing that the
final product (for instance a machine or plant) into which our
product has been installed, complies with the country-specific
regulations, safety instructions and application standards.
R911340198, Edition 02, Bosch Rexroth AG
.
Icons on the product
Icon
Meaning
Dangerous electrical voltage
Lug for connecting PE conductor only
Function ground, ground with low parasitic voltage
Connection of shield conductor only
Transport and storage
CAUTION
Heavy loads and sharp metal edges
Higher risk of injuries through lifting of excessive weights, bruises or
cutting!
When you plan and perform the work, please always note the
weight of the product (refer to the technical data in the
Operating Instructions) and use appropriate hoisting and
transportation equipment, if necessary.
Wear appropriate working clothes and use suitable protective
equipment (e.g. protective helmet/shoes, protective gloves).
NOTICE
Storage
Possibility of leak in the heat sink, contamination of the cooling
agent!
Make sure that the cooling system is fully drained prior to
storage.
Please note the maximum storage temperature range from
-25°C up to +70°C of all components.
Werbung
