Working With The Machine - Westfalia DSS18Li Originalanleitung

 Ensure that the charger is disconnected from the mains supply after
use, and is stored correctly.
 Do not leave batteries on charge for extended periods and never
store batteries on charge.
 The battery charger monitors battery temperature and voltage while
charging. Remove the battery once charging has been completed to
maximise charge cycles of the battery and not waste power.
 Batteries can become faulty over time, individual cells in the battery
can fail and the battery could short. The charger will not charge
faulty batteries. Use another battery, if possible, to check correct
functionality of the charger and purchase a replacement battery if a
faulty battery is indicated.
 Do not store Lithium-Ion battery packs in a discharged state long
term. This can damage the Lithium-Ion cells. For long-term storage,
store batteries in a high charge state disconnected from the power
tool.
 The capacity of batteries will reduce over time. After 100 charge
cycles, the battery's operation time and the maximum torque per-
formance of the tool will slightly reduce. This decline will continue
until the battery has minimal capacity after 500 charge cycles. This
is normal and not a fault with the battery pack.
Operation
Please Notice: Do not operate the grinding machine without the
protective covers over the grinding discs.

Working with the Machine

Please Notice: When working with the machine always wear protective
goggles with non-splintering lenses.
The work piece may heat up excessively during grinding.
Do not press the locking button while the grinding disc is rotating.
When working with the machine always use the workpiece rest and the
protection hood.
1. Loosen the locking screw (3) for the work piece rest (4) and adjust
Operation
21