◆
Front of device and operating panel
•
Clean the front of the device and the operating panel with a soft, slightly damp cloth.
•
Please bear in mind that the operating panel does not get wet. Use a soft, damp cloth
for cleaning.
► Leave the oven door open to prevent the device from being re-started accidentally.
◆
Exterior housing
•
Clean the exterior surfaces of the device with a damp cloth.
◆
Metal rack, baking sheet and ceramic base plate
•
The metal rack and baking sheet must be removed and cleaned occasionally. Wash
them in a warm soapy solution or in the dishwasher.
•
Wipe the bottom of the oven with a mild cleaning agent. If the floor of the oven is
excessively dirty, you can use a mild cleaning agent.
16 Troubleshooting
This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:
16.1 Safety notices
► Only qualified electricians, who have been trained by the manufacturer, may carry out
any repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and
damages to the device.
16.2 Fault indications
In the event of a fault, an error code will appear in the display; it describes the cause of the
fault.
Error
code
E01
Excessive temperature within cooking chamber
The overheating cut-out terminated the current program at a cooking
chamber temperature of 250°C. Press the Stop button to acknowledge this
fault. The device can be re-activated after the cool down phase.
E03
Sensor fault:
The device has detected an error on a sensor and has terminated the
current programme. Press the Stop button to acknowledge this fault.
Please note
Attention
Description
80