Troubleshooting; Safety Notices; Fault Indications; Causes And Rectification Of Faults - CASO DESIGN MCG25 Ceramic chef Original Bedienungsanleitung

Metal rack, baking sheet and ceramic base plate


The metal rack and baking sheet must be removed and cleaned occasionally. Wash
them in a warm soapy solution or in the dishwasher.

Wipe the bottom of the oven with a mild cleaning agent. If the floor of the oven is
excessively dirty, you can use a mild cleaning agent.

16 Troubleshooting

This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:

16.1 Safety notices

► Only qualified electricians, who have been trained by the manufacturer, may carry out
any repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and
damages to the device.

16.2 Fault indications

In the event of a fault, an error code will appear in the display; it describes the cause of the
fault.
Error
code
E01 Excessive temperature within cooking chamber
The overheating cut-out terminated the current program at a cooking
chamber temperature of 250°C. Press the Stop button to acknowledge this
fault. The device can be re-activated after the cool down phase.
E03 Sensor fault:
The device has detected an error on a sensor and has terminated the
current programme. Press the Stop button to acknowledge this fault.
► If error messages continue to appear after an extended waiting period and restarting the
device, then the device will need to be sent to Customer Service to be inspected.

16.3 Causes and rectification of faults

The following table assists in localizing and rectifying minor faults.
Error
Attention
Please note
Possible cause
Device door is not closed
Description
Close device door
Action
81