Corghi ProLine 650 Betriebsanleitung Seite 69

When the procedure is called up, the fol-
lowing appears on the left display: "OP.1".
OPT 1
- Move valve to 12 o'clock;
- Confirm the operation by pressing the
key.
OPT 2
- Rotate the wheel until you reach the posi-
tion indicated by the illuminated central
elements of the position indicator;
- Mark the 12 o'clock position on the outer
tyre side using a piece of chalk;
- Press the button;
- If the key is pressed now, the
system temporarily exits from the OPT
programme (to return, repeat the initial
OPT programme activation procedure);
- Disassemble the wheel from the wheel
balancer;
- Rotate the tyre on the rim until the previ-
ously done chalk mark is in line with the
valve (180° rotation).
- Remount the wheel on the wheel bal-
ancer;
- Turn the wheel until the valve is in the
12 o'clock position;
- Press the button;
- Perform a spin.
The improvement preview can be dis-
played before continuing with the last
phase of the optimisation procedure. If the
improvement is considered insufficient or
if no further significant improvements can
be achieved, press the
Proceed as follows to display the improve-
ment that can be achieved:
User manual ProLine 650
- Press the
unbalance values of the wheel as currently
mounted on the wheel balancer are now
shown on the displays;
- Press the
balance values indicated on the displays
are the values that can be achieved by
continuing with the last phase of the
optimisation procedure;
- When the
the third time, the machine prepares for
the last phase of the OPT programme.
- Rotate the wheel until you reach the posi-
tion indicated by the illuminated central
elements of the position indicator;
- Make a double mark on the outer side
of the tyre at the 12 o'clock position with
a piece of chalk. If the screen indicates
that the tyre should be switched around
on the rim, make a double mark on the
inner side using a piece of chalk. The user
can switch from the "with reversal" to the
"without reversal" mode by pressing the
- Press the
- Disassemble the wheel from the wheel
balancer;
- Turn the tyre (and reverse its mounting
if necessary) on the rim until the double
chalk mark is in line with the valve;
- Remount the wheel on the wheel bal-
ancer;
key to exit.
- Press the
performed rotation;
- Perform a spin.
button once: the actual
button again: the un-
button is pressed for
OPT 3
key;
button;
button to confirm the
UK
69