Corghi A 2030 Betriebsanleitung Seite 118

The TI version facilitates bead insertion and inflation of Tubeless tyres through the
emission of a strong jet of air from the nozzles placed near the locking wedges.
Before starting with the operations described below, make sure there is no dirt, dust
or other impurities near the inflation nozzles. It is advisable to wear protective goggles.
horizontal arm to the wheel centre (all slipped off
towards the operator)
- Make sure that the wheel is secured to the turntable
from the inner side (fig. 34).
- Lower the vertical arm until it touches the rim (fig.
35), then clamp the arm in this position (fig. 35a).
- Remove the valve core if it has not already been
removed (Fig. 36).
- Connect the Doyfe connector of the inflating hose
to the valve stem (Fig. 37).
A 2030 - A 2025 - A 2022 - A 2018 - A 224 A - A 224 Operator's manual
118
CAUTION
- Verify that both upper and lower tyre beads and
rim bead seat have been properly lubricated with
an approved mounting paste.
34
- Move the
35a
36
35
37