Main Working Elements Of The Machine - Corghi AGTT 1600A Betriebsanleitung

WARNING
Only original CORGHI equipment is recommended for use with the machine.
Fig.10 shows the safety distances and the positions used by the operator during the
various work phases:
A Positioning the wheel on the turntable
B REAR bead breaking
C FRONT bead breaking, demounting and mounting.
mAIn WorKInG ElEmEnTS oF THE
mACHInE
WARNING
Get to know your machine: your familiarity with its exact operation is the best guar-
antee of safety and performance.
Learn the function and location of all commands.
Carefully check that all controls on the machine are working properly.
The machine must be installed properly, operated correctly and serviced regularly in
order to prevent accidents and injuries.
See fig.10.
A Main switch
B Control lever
C Pressure gauge
D Lifting point
E Electrohydraulic power unit
F Turntable
G Bead breaker disc
UK
H Tool
I Tool arm
Start the machine with the main switch (A, Fig. 11) and make sure that the hydraulic
power unit motor is rotating in the direction indicated by the arrow (A, Fig. 12) which can
be seen on the motor cap.
Otherwise, the rotation direction must be corrected immediately in order not to damage
the pump unit.
All machine parts are powered by low voltage (24V) with the exception of the hydraulic
power unit and the turntable rotation motor inverter, which are powered with mains
voltage.
WARNING
Make sure that all parts of the hydraulic circuit are tightened correctly. If pressurised
oil escapes, it can cause serious injury.
Operator's manual AGTT 1600A - AGTT 1600 41