Troubleshooting - Scheppach SPECIAL EDITION HC24 o Originalanleitung

12. Troubleshooting

Fault
The compressor does
not start.
The compressor starts
but there is no pressure.
The compressor starts,
pressure is shown on
the pressure gauge, but
the tools do not start.
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Downloaded from www.Manualslib.com
Possible cause
• No supply voltage.
• Insuffi cient supply voltage.
• Outside temperature is too low.
• Motor is overheated.
• The non-return valve leaks.
• The seals are damaged.
• The drain plug for condensation water (10)
leaks.
• The hose connections have a leak.
• A quick-lock coupling has a leak.
• Insuffi cient pressure set on the pressure
regulator (4).
manuals search engine
GB
FR IT CK
DE
Remedy
• Check the supply voltage, the power plug and the
socket-outlet.
• Make sure that the extension cable is not too
long. Use an extension cable with large enough
wires.
• Never operate with an outside temperature of
below +5° C.
• Allow the motor to cool down. If necessary,
remedy the cause of the overheating.
• Have a service center replace the non-return
valve.
• Check the seals and have any damaged seals
replaced by a service center.
• Tighten the screw by hand. Check the seal on the
screw and replace if necessary.
• Check the compressed air hose and tools and
replace if necessary.
• Check the quick-lock coupling and replace if
necessary.
• Increase the set pressure with the pressure
regulator.
SK PL HU
21 / 76