Part Names Of The Projector; Attaching The Lens Cap - NEC HT1100 Bedienungsanleitung

Part Names of the Projector

Ventilation (outlet)
Heated air is exhausted from here
Adjustable Tilt Foot Lever (See page E-19)
* This security slot supports the MicroSaver
trademarked and owned by Kensington Microware Inc.
Remote Sensor (See page E-10)
AC Input
Connect the supplied power cable's three-pin plug here, and plug the
other end into an active wall outlet. (See page E-17)

Attaching the lens cap

To attach the lens cap to the bottom with the supplied string and rivet:
1. Thread the string through the
hole on the lens cap and then
tie a knot in the string.
Downloaded from www.Manualslib.com
Remote Sensor (See page E-10)
Adjustable Tilt Foot (See page E-19)
® Security System. MicroSaver
PC Card Slot
Rear Foot
manuals search engine
Focus Ring (See page E-20)
Controls (See page E-7)
Lens Cap
® is a registered trademark of Kensington Microware Inc. The logo is
PC Card Eject Button
VID EO VID EO
S-V IDE S-V IDE
PC CO O O COM PON
NT RO
L ENT
VID EO RG B/D RG B/D
VI VI
IN S- AU DIO AU DIO
IN IN
VID EO SC TR
IN
IG GE R
Y
Cb /Pb
Cr/ Pr
CO MP
UT ER
IN
DV I-D
IN
Main Power Switch
When you plug the supplied power cable into an active wall outlet and
turn on the Main Power switch, the POWER indicator turns orange and
the projector is in standby mode. (See page E-18)
2. Use the rivet to attach the
string to the bottom of the
projector.
E-6
Ventilation (inlet)
Built-in Security Slot ( )*
Zoom Lever (See page E-20)
Carrying Handle
Lens
Iris Lever (See page E-20)
Stereo Speaker (2W)
Lamp cover (See page E-43)
Ventilation (outlet)
Heated air is exhausted from here
Lamp cover screw
Rear Foot
Rotate to make the projector level. (See page E-20)