Layout; Proper Use; Technical Data; Before Starting The Machine - EINHELL BH 2000 Originalbetriebsanleitung

Anleitung_BH_2000_SPK7:_
GB
CAUTION
Read all safety regulations and instructions. Any
errors made in following the safety regulations and
instructions may result in an electric shock, fire and/or
serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
2. Layout (Fig. 1)
1. ON/OFF switch
2. Thermostat controller
3. Air outlet
4. Wall mount
5. Fixing bracket
6. Installation material

3. Proper use

The appliance is designed as a wall heater in the
bathroom, toilet, cellar, hobby rooms, etc).
The appliance may only be used for the tasks it is
designed to handle. Any other use is deemed to be a
case of misuse. The user/operator - not the
manufacturer - will be liable for any damage or
injuries caused as a result thereof.
Please note that our appliance has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
appliance is used in commercial, trade or industrial
businesses or for equivalent purposes.

4. Technical data:

Rated voltage:
Output:
Thermostat control:
Protection class:
Mains lead:
10
27.04.2009 15:31 Uhr Seite 10

5. Before starting the machine

5.1 Wall mounting (Fig. 2)
The appliance may only be used when mounted on a
wall. Maintain all minimum distances. The appliance
may only be used when completely assembled and
standing vertically.
The minimum separation distances of 25cm at the
sides, 60cm away from the ceiling, 60cm away from
the floor and 60cm at the front are to be observed.
See section 1 "Safety regulations".
Caution: Make sure that there are no electric cables
or other installations (for example water pipes) near
the drill holes. Ensure that the appliance is secured
firmly and horizontally to the wall. Use only suitable
fastening material on a suitably stable wall. The
supplied dowels and screws are suitable for the
following: Concrete, natural stone with a dense
structure, solid brick, solid limestone bricks, solid
lightweight concrete bricks and aerated concrete.
When selecting the location for the appliance,
please note that if there are skirtings on the floor,
the minimum distance to the housing, or the
installation height, has to be measured from the
top of the skirting.
Lastly both fastening holes of diameter 8mm for
the wall bracket (4) are to be marked and drilled
horizontally with a separation distance of 225mm
and must be located at least 1000mm above the
floor (observing borders).
Screw the wall bracket (4) to the wall.
Hang the bathroom heater in the slots of the wall
bracket.
Fasten the bathroom heater additionally to the
lower fixing bracket (5) on the wall.

6. Operation

230 V ~ 50 Hz
2000 W
Caution: Before using the appliance for the first time,
Infinitely adjustable check that the voltage supply is the same as the
voltage details set out on the rating plate. Read the
I
safety regulations in section 1.
3 x 1 mm 2
When the appliance is used for the first time or after a
long period of rest it may emit an odour for a short
time. This is not a fault.