Emptying Dry Dust From The Waste Material Container - Hilti VC 20-UM Original Bedienungsanleitung

CAUTION
Risk of injury. Hazardous material that has been picked up may escape if a filter element is not used.
▶ Never use the appliance without a filter element.
▶ Check that the filter element is dry and that the correct type of dust bag is fitted.
6.4 Changing the fabric dust bag
DANGER
Risk of injury. Sharp pointed objects may pierce through the dust bag.
▶ Check that no objects have pierced through the dust bag.
1. Pull the plug out of the power outlet.
2. Open the two catches.
3. Lift the vacuum cleaner top section away from the waste material container.
4. Close the cap at the mouth of the dust bag.
5. Clean the waste material container with a cloth.
6. Secure the new fabric dust bag in the waste material container.
7. Fit the vacuum cleaner top section onto the waste material container and close the two catches.
6.5 Changing a plastic dust bag
1. Disconnect the supply cord plug from the power outlet.
2. Open the two catches.
3. Lift the vacuum cleaner top section away from the waste material container.
4. Use a cable tie to close the plastic dust bag below the punched holes.
5. Remove the plastic dust bag.
6. Clean the waste material container with a cloth.
7. Fit a new plastic dust bag (see instructions printed on it) in the waste material container.
8. Fit the vacuum cleaner top section onto the waste material container and close the two catches.
6.6 Picking up liquids
CAUTION
Risk of injury. Hazardous material that has been picked up may escape if a filter element is not used.
▶ Never use the appliance without a filter element.
1. Check the container level monitoring system. → page 23
2. If possible, use a separate filter element for wet applications.
The Hilti VC 20/40 universal (2121387) filter is recommended.
3. After picking up liquids, open the two catches.
4. Lift the vacuum cleaner top section away from the waste material container and place it on a level surface
so that the filter element can dry.
5. Empty the waste material container and use a water hose to rinse it out. Use a brush to clean the
electrodes and clean the filter element, after allowing it to dry, by wiping it off with your hand.
6. Allow the waste material container to dry.
6.7

Emptying dry dust from the waste material container

1. Disconnect the supply cord plug from the power outlet.
2. Lift the vacuum cleaner top section away from the waste material container and place it on a level surface.
3. Remove the dust bag from the waste material container or grip the container by the recess provided and
empty it by tipping out the contents.
4. Fit the vacuum cleaner top section onto the waste material container and close the two catches.
22 English
3
4
224936
*224936*