hanseatic HEKS8854F Gebrauchsanleitung Seite 48

Setting up the refrigerator
Your mounting materials:
No. Name
8 Joint profile
9 Door couplers
10 Cover strips, long
11 Elbows
12 Cover strips, short
13 Screws
1. Remove the glass shelves 7 and 6, vegetable drawers 5 and
the door shelves 3 from 4 from the refrigerator.
2. Screw the elbows 11 using the screws 13 on to the refrigera-
tor door (pre-pierce the holes using a Ø 2.5 mm nail).
3. Insert the refrigerator into the built-in cabinet.
The spacing between the refrigerator and the lower edge of the
built-in cabinet must be approx. 40 mm.
To make sure the joint profile can be clamped, a gap of 4 mm
in the entire height between the refrigerator and built-in cabinet
must be retained on the opposite side of the door hinges.
4. Screw the refrigerator to the built-in cabinet using the
screws 13.
5. Connect the mains plug to a properly installed socket.
6. Open the refrigerator door out as far as possible. Push the
door couplers 9 into the guide rails of the elbows 11.
18
Quantity
1
2
2
2
2
12
8
9
10
11
12
13
40 mm
18 mm
90°
HEKS8854F