Maintenance And Care; Serial Number - Minox X-range 10x42 Bedienungsanleitung

Setting EHD:
Measurement reading
In this setting, the distance in the direct line of sight to the
object is indicated in the upper part of the display. The angle
in relation to the corrected distance measurement (equivalent
horizontal distance) is indicated in the lower part of the display.
Button configuration
Default setting: Measurement button right
The function of the two control buttons on your binoculars can
be swapped. This increases your operating convenience if you
are left or right handed. The assignment of the buttons can be
changed by moving the circle in the display to the right or left.
The side on which the circle is located, represents the side of
the measuring button.
Scan mode
With this function you can perform continuous measurements.
Measurements are triggered every ¼ of a second. You can ac-
tivate the scan mode by continuously pressing the measuring
button while measuring the distance. After 3 seconds, scanning
is activated and all functions are constantly updated according
32 32
to the display settings. Upon releasing the measuring button,
the device will automatically return to the normal measuring
functions. This can be helpful in determining the distance to
moving objects.
Battery indicator
The battery indicator will flash if the battery voltage drops be-
low 2.4 Volts. This is an indication that you should change the
battery soon. If the battery voltage drops below 2.3 Volts, the
device will automatically switch off.

MAINTENANCE AND CARE

To provide as much protection as possible for your MINOX
binoculars, it is recommended to use the carrying case when
storing your binoculars.
Cleaning the binoculars
Keep your MINOX binoculars clean and dry. Avoid exposing the
binoculars to extreme heat. Remove dust and foreign particles
on the housing with a soft moist cloth. If your binoculars have
been used at a lake or have been exposed to salt water, we
recommend that you rinse them with fresh water. Over a period
of time, sea salt can damage the objective lenses and optical
quality of your binoculars.
Cleaning the objective and ocular lenses
Contamination of the lenses by foreign bodies like sand, dust,
grease, drops of water or fingerprints reduce the image quality
of your MINOX binoculars (image sharpness and contrast). For-
eign bodies should be carefully removed using a very soft brush
before cleaning the lenses.
Heavier contamination or fingerprints on the lenses can be re-
moved with an optical cleaning cloth and special lens cleaner.
We recommend using the MINOX optical cleaning set (order no.
80405463). You can also obtain other suitable optical cleaning
agents from specialist retailers.

SERIAL NUMBER

The serial number can be found on the underside of the battery
compartment cover, after you have removed it.
33 33