Herunterladen Inhalt Inhalt Diese Seite drucken

cecotec Total Iron Expert 8500 Implode Bedienungsanleitung Seite 25

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 40
ENGLISH
When it's not being used, the steam
supply tube
and power cord can be wound along the cord
slot for storage.
Automatic power off
The appliance will turn off automatically after 10 minutes
of inactivity.
Dry ironing
Place the iron on the heatproof stand of the unit base.
Connect the plug to a wall outlet, the temperature indicator and the indicator of MAX. steam
rate will turn on.
Turn temperature dial to select the desired temperature setting depending on the garment's
fabric, the iron will start heating up.
When the selected temperature is reached, the temperature indicator will turn off. Then, you
can start ironing.
Warning: Do not touch the soleplate before it cools down!
Steam ironing
Grasp the water tank's handle to remove the water tank, then fill it with water through the
filling aperture. Use purified water with few calc particles. After this, replace the water tank
properly. The max capacity of water tank is 1.8L, the water level should not exceed the MAX
mark.
Place the steam station on the thermal insulation stand of the unit base.
Connect the plug to the wall outlet, press the power switch, and the defaulted low steam rate
indicator will flash. There are three modes including low, medium and high steam rate, you can
select the desired steam rate for each garment according to your requirement. Make sure that
there is enough water in the tank.
Turn the temperature dial to desired setting taking into account the fabric, and the temperature
indicator will illuminate. The steam station will start emitting heat. Refer to "ironing tips" and
"additional table" below when setting the temperature.
The water in the steam generator will be heated, after a few minutes, then the temperature
indicator will switch off. This indicates that the soleplate temperature has achieved the
selected temperature. When the indicator of defaulted steam rate changes from flashing to
illuminating, it indicates that the iron is ready for ironing the garment.
Gently press the steam trigger for steam to be sprayed from the soleplate continuously.
Warning: Never direct the steam at people!
After ironing, press the power switch for about 2 seconds, the appliance will switch off and
with it, all the indicators. Remove the plug from the wall socket. Be careful, the soleplate will
still be hot, never touch it with your hand. Place it on the heatproof stand until it cools down
completely.
Ironing tips
Always check first whether a label with ironing instructions is attached to the article. Follow
TOTAL IRON 8500 IMPLODE / 9000 TURBO-BOOST
25
Total Iron 8500 Implode 9000 Turbo-Boost.indd 25
15/11/19 15:00

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Total iron expert 9000 turbo boost

Inhaltsverzeichnis